Cardo Q2 PRO XL Guide de l'utilisateur

User Guidecommunication in motion™™Q2™pro

MC BUTTON CONNECT:Double tap the MC Button A Buddy Intercom call will be established. To end the Buddy Intercom call, double tap the MC Button again.N

EnglishDuring Standby, press and hold the Volume Up Button for three seconds and you will hear a beep:• One beep – Voice Connect set to Primary Buddy•

strongest signal available for the FM station you wish to listen to, no matter where you are riding. This allows you to leave your hands on the handle

Englishheadset.While listening to music from an A2DP source, you will not miss any mobile or intercom calls, as the headset will automatically stop th

cable holder.Make sure that the cable plug clicks into place.7. Tuck the MP3 cable into the hook of the MP3 cable holder. 8. In order to use your MP3

Englishinterference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipm

and that you have given up substantial rights by not returning the Device for a full refund (see refund option below).Disclaimer of Warranty CARDO DIS

© Cardo Systems, Inc.The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Cardo Systems, Inc. is under

EnglishCONTENTS OF RETAIL BOX INTRODUCTIONCongratulations, and thank you for choosing the scala rider Q2 pro Bluetooth® Headset. This Manual will hel

Wall ChargerAllen WrenchVelcro PadsMP3 CableMP3 Cable HolderGlue PlatePre-moistened ToweletteCarry-PouchMicrophone Sponges Flat sponge for full-face h

EnglishPRIMARY BUDDY PAIRING (requires two scala rider Q2 pro headsets*)1. If either headset is turned OFF, turn it ON by pressing and holding the CTR

When using an earlier scala rider headset as a Passenger headset, Voice Connect Intercom can be initiated only by the scala rider Q2 pro headset. Manu

EnglishTo Pair the scala rider Q2 pro to a Bluetooth GPS Device:1. Turn on your GPS device.2. With the scala rider Q2 pro headset turned ON, press and

1. Use the enclosed Allen Wrench to remove both Allen screws and release the Helmet Clamp’s back plate.2. Determine the location on the helmet where t

EnglishATTACHING AND REMOVING THE HEADSET FROM THE HELMET CLAMPATTACHING:Slide the headset downwards along the sliding panel until a clicking sound in